Skip to content
Point 2 Point Communications
A technician in a climbing harness and helmet working on a steel tower.

Services

We cover the whole life of a system: the survey that tells you whether you need one, the design, the approvals, the installation, the acceptance test and the yearly test after that.

  1. Looking down the open centre of a square stairwell, floor after floor.

    Signal surveys and coverage assessments

    For: Existing buildings, new construction, buildings changing hands

    We measure the public-safety signal outside and inside the building and record where it holds and where it fails, floor by floor.

    • Readings marked on your floor plans
    • A plain answer: is a system likely to be needed, and roughly what kind
  2. Riser diagram of an in-building public-safety radio systemA donor antenna on the roof connects through a cable riser to a bi-directional amplifier (BDA) and backup battery in a ground-floor riser room. The riser feeds a ceiling antenna on each of six floors. The BDA reports trouble signals to the fire alarm panel.L6L5L4L3L2L1BDACeiling antennaFire alarm panelDonor antennaCable riserBDA (amplifier)Backup battery

    System design

    For: Anyone who needs a system built or replaced

    A design for your building and your fire department's radio channels, put together as the document set NFPA 1225 asks for.

    • Link budget and donor-to-DAS isolation calculations
    • Predicted coverage on your floor plans
    • Backup power calculations and the fire alarm monitoring design
    • Equipment data sheets and test grids
  3. A radio operator at a desk of mobile radios speaks into a handheld microphone.

    Permits and approvals

    For: Every new system and every change to one

    We submit plans to the fire marshal and line up the approvals a system needs before it can be switched on.

    • Plan submittal and responses to review comments
    • Written authorization from the frequency license holder
    • FCC signal booster registration where the equipment requires it
  4. Two technicians in hard hats and high-visibility vests on a building roof: one climbs an antenna mast while the other checks a laptop.

    Installation

    For: New construction and retrofits in occupied buildings

    Donor antenna, amplifier, cable or fiber up the riser, antennas on each floor, fire alarm supervision and backup power.

    • Labeled equipment and cable
    • As-built drawings showing every component
  5. A concrete column in a parking garage with a sign for level 5 and the stairs.

    Acceptance testing

    For: Before the fire marshal signs off

    A grid test on every floor and a separate check of critical areas, plus a test of each supervisory signal at the fire alarm panel.

    • Test results for every location covered
    • Equipment list, settings and secondary power calculations
    • The documentation package your fire marshal asks for
  6. Steel stair flights seen from below, stacked floor over floor.

    Annual testing, inspection and repair

    For: Every building with a system

    NFPA 1225 calls for a documented test every 12 months. We run it, fix what fails and keep the records. When an agency changes its radio frequencies, we update the system to match.

    • A yearly test and signed report
    • Trouble-signal response and repairs
    • Frequency change upgrades
  7. A dark concrete stairwell leading up to a lit doorway.

    Failed inspections and existing systems

    For: Owners with a system that doesn't pass, or a violation notice

    We find out why coverage falls short, whether it's the donor link, the amplifier, the antenna layout or the cabling, and fix it.

    • A diagnosis in writing
    • A repair or retrofit plan you can take to the fire marshal

Who we work with

  • Building owners and property managers
  • Developers and general contractors
  • Electrical and fire alarm contractors
  • Architects and engineers

Equipment

We pick equipment for each building and for the radio channels your fire department uses. Equipment brands we work with include Westell and PCTEL.

If you aren't sure which of these you need, start with a signal survey. Request a signal survey